User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
c.
If you elected to assign a static IP to the instrument, touch the following
fields and enter the:
• IP Address – Enter the static IP address for the instrument.
• Netmask – Enter a subnet mask for the network if applicable.
• Gateway – Enter a default gateway for the network if applicable.
Note: For each setting, touch the associated field, then enter the setting
using the keypad and touch Enter to accept the value.
d.
Touch , then configure the domain name service (DNS) settings:
• DNS Domain – Enter the domain name of the DNS server that you
want the instrument to use.
• DNS Server – Enter the IP addresses for the primary (top) and
secondary (bottom) DNS servers.
IMPORTANT! DNS settings are required if you:
·
Specify the QuantStudio
®
3D AnalysisSuite
™
Cloud Software as a data
destination.
·
Want to use Network Time Protocol (NTP) for instrument date/time
synchronization.
Appendix B Networking
Connect the instrument to the network
B
QuantStudio
®
3D Digital PCR System User Guide
101