User guide
Table Of Contents
- QuantStudio 3D Digital PCR System User Guide (Pub. no. MAN0007720 Rev. C.0)
- Copyright Page
- Contents
- About this guide
- Chapter 1. Getting Started
- About the QuantStudio® 3D Digital PCR System
- Operating the instrument
- Prepare the QuantStudio® 3D Digital PCR System for use
- Connect the QuantStudio® 3D Instrument to a network
- Connect the QuantStudio® 3D AnalysisSuite™ Software
- Chapter 2. Prepare Samples and Load Reactions
- Chapter 3. Perform the PCR
- Chapter 4. Analyze the Prepared Chips
- Chapter 5. Troubleshooting
- Appendix A. Maintenance
- Appendix B. Networking
- Appendix C. Parts and Materials
- Appendix D. Specifications and Layout
- Appendix E. Safety
- Documentation and support
- Back Cover
d.
If your selected wireless hotspot is secure, enter the required authentication
information (user name/password), then touch OK.
If connecting your instrument to a network that supports DHCP, network setup
is complete. Otherwise, go to the next step to configure the TCP/IP settings for
the instrument.
6.
Set the internet protocol (TCP/IP) properties for the
QuantStudio
®
3D
Instrument:
a.
In the Network Setup screen, touch Edit Settings.
b.
In the Network Setup settings, touch the IP Configuration field, touch the
setting appropriate for your network (Static IP or DHCP), then touch OK.
• DHCP – Select to allow your network DHCP server to automatically
assign an IP address to the instrument.
• Static IP – Select if you have a static IP address to assign to the
instrument.
Appendix B Networking
Connect the instrument to the network
B
100
QuantStudio
®
3D Digital PCR System User Guide