User`s guide

Chapter 2

QDSP

2030 User’s Manua

 Memory Module Installation

Remove the chassis bottom cover

Loosen one flathead screws and remove the chassis bottom cover. You’ll see the

SO-DIMM socket of the motherboard.

Carefully follow the steps below in order to install the DIMMs:

1. To avoid generating static electricity and damaging the SO-DIMM, ground

yourself by touching a grounded metal surface or use a ground strap before you

touch the SO-DIMM.

2. Do not touch the connectors of the SO-DIMM. Dirt or other residue may cause a

malfunction.

3. Hold the SO-DIMM with its notch aligned with the memory socket of the board

and insert it at a 30-degree angle into the socket.

Figure 7 Align the SO-DIMM Memory Module with the onboard socket

4. Fully insert the module into the socket until a “click” is heard.

5. Press down on the SO-DIMM so that the tabs of the socket lock on both sides

of the module