User`s guide

Power Connection 3-3KUBE-8110 User’s Guide
X Power Connection
X DC Power
1) Make sure the power distribution to the DC power feed wires is disconnected.
2) Remove just enough insulator material from the ends of the wires to allow a proper electrical
connecti
on to the terminal block.
3) Insert the power feed wires into the terminal block
and tighten the compression clamps on the top
side of the terminal block.
Power
Inlet
tighten compression
clamps
Figure 3-1. Tighten the terminal block compression clamps on the DC inlet
4) Connect the power distribution to the DC power feed wires.