User`s guide

Chapter 2
23
KEMF-4010 User’s
Table 14 VGA_COM1, RS-232 / 422 / 485 Port 1 DB15+DB9 Connector
Pin Signal Name Pin Signal Name
V1 Red V2 Green
V3 Blue V4 NC
V5 GND V6 GND
V7 GND V8 GND
V9 +5V V10 GND
V11 NC V12 DDC data
V13 HSYNC V14 VSYNC
V15 DDC clock
C1 RS-232：DCD,
Data carrier detect
RS-422：TX-
RS-485：DATA-
C2 RS-232：RXD,
Receive data
RS-422：RX+
RS-485：N/A
C3 RS-232：TXD,
Transmit data
RS-422：TX+
RS-485：DATA+
C4 RS-232：DTR,
Data terminal ready
RS-422：RX-
RS-485：N/A
C5 GND, ground C6 DSR, Data set ready
C7 RTS, Request to send C8 CTS, Clear to send
C9 RI, Ring indicato
r
C10 NC
[芬瑩 D201B1N01002N]
Note：COM 1 RS-232 / 422 / 485 can be selected in BIOS setup.
Note：RS-485 is half-duplex mode.
Table 15 LAN1,LAN2, LAN3, RJ-45 + 2 USB 2.0 Connector
Pin Signal Pin Signal
L1 VCC L12 YLED+
L2 MDI[0]+ L13 GLED-
L3 MDI[0]- L14 GLED+
L4 MDI[1]+ U1 +5VSV
L5 MDI[1]- U2 USB_
A
-
L6 MDI[2]+ U3 USB_A+
L7 MDI[2]- U4 GND
L8 MDI[3]+ U5 +5VSB
L9 MDI[3]- U6 USB_B-
L10 GND U7 USB_B+
L11 YLED- U8 GND
[UDE RU1-161F9WGF(XB)]
Table 16 LAN LED Status
Status Led Orange / Green Yellow
No link Off Off
10M link Off Off
10M active Off Blink
100M link Green on Off
100M active Green on Blink
1000M link Orange on Off
1000M active Orange on Blink