User`s guide

Chapter 2

KEMF-4010 User’s

Table 5 JP5, Parallel Port Signal Selection

Jumper Setting Function

1-2 Short Pin 4 of LPT1 = ERR# (Default)

1-3 Short Pin 4 of LPT1 = +5V

4-6 Short Pin 6 of LPT1 = +5V

5-6 Short Pin 6 of LPT1 = INIT# (Default)

7-8 Short Pin 8 of LPT1 = SLIN# (Default)

7-9 Short Pin 8 of LPT1 = +5V

Pitch:2.54mm NY 6T[YIMTEX 3362*05SANGR]

Table 6 JP8, ATX/AT mode Selection

Jumper Status

Open ATX mode(Default)

Short AT mode

Pitch: 2.0mm [YIMTEX 3291*02SAGR(6T)]

Table 7 JP9, Clear CMOS Selection

Jumper Status

1-2 Normal Operation (Default)

2-3 Clear CMOS

Pitch: 2.0mm [YIMTEX 3291*03SAGR(6T)]

Remark: You must go to BIOS EXIT menu to do “Load Optimal Defaults” after

clear CMOS.

Table 8 JP11, Panel Power Selection

Jumper Status

1-2 +3.3V(Default)

2-3 +5V

Pitch: 2.54mm [YIMTEX 3321*03SAGR(6T)]

Note： If DVI cable is connecting to LVDS panel connector, the Pin2-3 should be shorted.

Table 9 JP12, Backlight Power Selection

Jumper Status

1-2 +12V(Default)

2-3 +5V

Pitch: 2.54mm [YIMTEX 3321*03SAGR(6T)]