Use and Care Manual

5
6
NOTE
Do NOT use power drill and do NOT over tighten the lag bolts.
Do NOT use concrete / brick anchors (B) for drywalls.
Mounting to a Concrete or a Brick Wall
2b
Hold the marking template provided against the wall where you want to install the TV, mark
three holes for drilling.
1
2
3
ø 10mm
(ø 3/8")
Marking Template
Level
70mm
70mm
(2.7")
(2.7")
Mount the wall plate and tighten with the provided lag bolts (A) and D6 washers (C) using a
socket wrench.
Place concrete anchors (B) in each hole. Tap each anchor flush with the wall using a hammer. Mount
the wall plate and tighten with the provided lag bolts (A) and D6 washers (C) using a socket wrench.
SKIP TO STEP 3
A
C
Concrete Wall
A
C
B
Using a power drill and a 3/8" masonry drill bit, drill mounting holes of 3/8" (10mm) diameter and 2.7"
(70mm) depth at the marked locations in the previous step.
WARNING

Installers must verify that the
supporting surface will safely
support the combined weight of
the equipment and all attached
hardware and components.
Installing the Decorative Covers
3
Wall
Decorative Covers
Insert the decorative covers along the wall plate rail until they fit snuggly onto the wall plate.
5