Manual

FALL CLEARANCE CALCULATION
Lanyard length
(6’ total)
Safety factor
(3’ total)
Deceleration
distance (4’ total)
Height of harness
dorsal D-ring from
worker’s feet
(6’ total)
Required
distance
from
anchorage
(19’ total)
Limitations
Fall Clearance: There must be sufficient
clearance below the anchorage connector
to arrest a fall before the user strikes the
ground or an obstruction. When
calculating fall clearance, account for a
MINIMUM 3’ safety factor, deceleration
distance, user height, length of
lanyard/SRL, and all other applicable
factors. Diagram shown is an example
fall clearance calculation ONLY.
Swing Falls: Prior to installation or use, make considerations for eliminating or minimizing all
swing fall hazards. Swing falls occur when the anchor is not directly above the location where a
fall occurs. Always work as close to in line with the anchor point as possible. Swing falls
significantly increase the likelihood of serious injury or death in the event of a fall.
Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: (800) 466-6385 fax: (800) 670-7892 www.guardianfall.com
7
Fall Clearance:
Stingray Anchor and Absorbinator HLL System
70-80 18' 7'
80-90 19' 8"
90-100
20' 10"
*Clearance Table Using a
Self-Retracting Lifeline (SRL)
Span (FT) Required Distance
0-10 10' 11"
10-20
12' 0"
20-30
13' 1"
30-40
14' 2"
40-50
15' 4"
50-60
16' 5"
60-70
17' 6"
*This table only applies
when SRL and HLL are
located above harness
dorsal D-ring.
60-65
26' 1"
27' 1"
28' 1"
65-70
26' 8"
27' 8"
28' 8"
70-75
27' 5"
28' 5"
29' 5"
75-80
28' 0"
29' 0"
30' 0"
80-85 28 8" 29' 8" 30' 8" 31' 8"
85-90 29' 4" 30' 4" 31' 4" 32' 4"
90-95
30' 0"
31' 0"
32' 0"
95-100
30' 7"
31' 7"
32' 7"
Clearance Table Using Energy Absorbing Lanyards
Span Length
(FT)
4 FT
Lanyard
5 FT
Lanyard
6 FT
Lanyard
0-10
19' 11"
20' 11"
21' 11'
10-15
20' 7"
21' 7"
22' 7"
15-20 20' 2" 21' 2" 22' 2' 23' 2"
20-25
21' 11"
22' 11"
23' 11"
25-30
22' 6"
23' 6"
24' 6"
30-35
23' 2"
24' 2"
25' 2"
35-40
23' 10"
24' 10"
26' 10"
40-45
24' 6"
25' 6"
27' 6"
45-50 24' 1" 25' 1" 26' 1" 28' 1"
50-55 24' 10" 25' 10" 26' 10" 28' 1-"
55-60
26' 5"
27' 5"
29' 5"