Instruction Manual

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
13
14. Insert (3) 2” x 4”, 10’ long Guardrails into corresponding rungs on Guardrail Posts. Ensure
that Guardrails will fully span two consecutive Top Clamp and Support Bracket assemblies, and
will overlap with adjacent Guardrails by a minimum of 12” on each end.
Minimum overlap: 12”
• Compatible Snap-On Metal Adjustable Guardrails (part #s 61075 and 61076, not included) may
be used in substitute of 2” x 4” lumber Guardrails. Snap-On Metal Adjustable Guardrails do not
require lapping. Both ends of Snap-On Metal Adjustable Guardrails MUST be fully locked onto
their corresponding Guardrail Post rungs.
Scaffold Planks and lumber Guardrails MUST overlap a MINIMUM 12” on each end.
!
WARNING
15. Complete entire run of Scaffold Planks and Guardrails. Ensure overlapping Scaffold Planks
and Guardrails are lapped in a continuous direction. Continuous lapping simplifies the
disassembly process.
16. If Toeboards are required, attach 2” x 4” lumber Toeboards with a compatible nail or screw
at all Toeboard Attachment locations.
2” x 4” Toeboard
Compatible nail/screw
at Toeboard Attachment
location