Product Manual

between brace arms is 32” thus enabling installation on studs 16”

on center. 2) Additional poles should be spaced based on the type

and style walk plank used. Additional poles should be installed in

the same manner as the st pole.

To pass an Ultra-Jack Brace: 1) When passing an Ultra-Jack

Brace that is already installed, an extra brace should be installed

approximately 4 feet above the one to be passed until the original

brace is re-installed. 2) After installing the temporary brace, loosen

the wing nut and allow the brace to be passed to swing clear of

the pole. Do not remove from wall. After brace has been passed

reconnect it to pole and remove the extra brace.

Care and use of the Ultra-Jack Scaffold System: 1) Prior to use

the user should inspect the installation to insure that the system is

properly set up and is ready for use. 2) An access ladder should be

used to provide safe access to the work platform. 3) Ultra-Jack Scaf-

folding must not be used over 48 feet off the ground. 4) There should

never be more than two people on an Ultra-Jack System between

any two poles. 5) Only one walk plank shall be supported between

any two poles. 6) Additional safet accessories such as guardrails,

mid-rails, toe-boards, fall arrest or harness systems must be used

as required by Local, State and Federal OSHA Regulations.

Customer Support and Ordering Information

781-344-1000 • www.qualcraft.com

Industries • 1551

ULTRA-JACK

OPTIONS INSTRUCTIONS

ULTRA JACK OPTIONS AND ACCESSORIES

MODELS #2002, @2004, #2008, #2009,

#2006, #2012, #2024, #2013