Users Manual

Approved antenna(s) list
Antenna
No.
Brand Model
Antenna
Net gain
Frequency
range
(GHz)
Cable
Loss
(dBi)
Ant.
Type
Connector
Type
Cable
Length
(mm)
1 WNC
81.EBJ15.005
3.00 2.4~2.4835 1.15
PIFA i-pex(MHF2) 300
2.56 5.15~5.35 1.70
4.76 5.47~5.725 1.74
4.76 5.725~5.850 1.79
2 WNC
81.EBJ15.005
3.62 2.4~2.4835 1.15
PIFA i-pex(MHF2) 300
3.08 5.15~5.35 1.70
3.31 5.47~5.725 1.74
2.42 5.725~5.850 1.79
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
J9C-QCNFA524”. The grantee's FCC ID can be used only when all FCC compliance
requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located
or simultaneous transmission with other transmitter(s) or portable use will require a
separate class II permissive change re-evaluation or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC
Part 15 Subpart B (unintentional radiator) rule requirement applicable to the final host. The
final host will still need to be reassessed for compliance to this portion of rule requirements
if applicable.
As long as all conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user’s manual of the end product which integrates
this module.
The end user manual shall include all required regulatory information/warning as show in this
manual.
OEM/Host manufacturer responsibilities
OEM/Host manufacturers are ultimately responsible for the compliance of the Host and