User guide

78 Palm Handhelds
To connect a Palm handheld to the Tri-Mode Phone
1. Turn off the power on your QUALCOMM Globalstar Tri-Mode Phone.
2. Connect the serial connector on the HotSync cable to your Palm.
3. Connect the null modem adapter to the other end of the HotSync cable.
4. Connect the 9-pin serial end of the Globalstar data cable to the null
modem adapter, and manually tighten the screws to hold it in place.
5. Holding the other end of the data cable, press both buttons on the side
of the connector, then insert it into your Tri-Mode Phone with the
arrow facing up (toward the phone’s keypad). The connector should
snap into place for a secure fit.
6. Turn on your Tri-Mode Phone.
Serial
connector
726AA_00
HotSync
cable and
connector
Null modem
adapter
730AA_00
Globalstar
data cable
9 pin serial
connector
Null modem
adapter
731AA_00
723AA_00