User guide

12 Windows Computers
To connect a Windows PC to the Tri-Mode Phone
1. Turn off the power on your QUALCOMM Globalstar Tri-Mode Phone.
You can leave your computer turned on.
2. Attach the QUALCOMM data cable’s 9-pin serial connector to a serial
COM port (RS-232) on your PC, then manually tighten the screws to
hold it in place.
3. Holding the other end of the QUALCOMM data cable, press both
buttons on the side of the connector, then insert it into your Tri-Mode
Phone with the arrow facing up (toward the phone’s keypad). The
connector should snap into place for a secure fit.
4. Turn on your Tri-Mode Phone.
5. Rotate or fully extend the appropriate antenna for the type of
connection you wish to make (Globalstar satellite or cellular).
Note
If you cannot obtain a signal with the Globalstar Satellite
Antenna in a 90
o
position, try rotating it further until you feel it
click into place.
723AA_00
724AA_00
Pwr
EndSend
Info Clr
1 4 7
2 5 8 0
3 6 9
*
#
+
abc def
jkl mno
tuv
ghi
pqrs wxyz
| menu | | book |
GLOBALSTAR
i
90°
Pwr
EndSend
Info Clr
1
4
7
2
5
8
0
3
6
9
*
#
+
abc def
jkl mno
tuv
ghi
pqrs wxyz
| menu | | book |
GLOBALSTAR
i
Pwr
EndSend
Info Clr
1
4
7
2
5
8
0
3
6
9
*
#
+
abc def
jkl mno
tuv
ghi
pqrs wxyz
| menu | | book |
GLOBALSTAR
i
Globalstar Satellite Antenna Cellular Antenna