User's Manual Part 2

Swing Door Sensor Installation Verification Installing the Swing Door Sensor
11-8
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
Swing Door Sensor Installation Verification
1. At the back of the trailer, butt splice the white sensor wires to the orange and yellow
cable wires. Add additional strain relief by following the procedure on page 3-7. Slide
convoluted tubing onto sensor wires, making sure to also cover the butt splices. Store
excess wire behind the taillight assembly.
2. Replace the taillight assembly.
3. At the front of the trailer, butt splice the orange and yellow cable wires to the orange and
yellow TT210 system door sensor wires at the TT210 system terminal.
Note
The sensor wire is a simple switch device; polarity does not matter.
4. Perform the door sensor validation as part of the TT210 system verification (see
Chapter 14: Performing System Verification).
5. The swing door sensor installation is now complete.
If you have technical questions about installing the TT210 system swing door sensor, please
contact QES Customer Support:
In the United States, call 800-541-7490;
in Canada, call 800-863-9191.
05AAA_246A
When the test is completed
and the circuit tests O.K. , splice
the sensor wires to the terminal wires.
Yellow
Orange
DRAFT