User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 11-7
Installing the Swing Door Sensor Testing the Swing Door Sensor
5. Apply adhesive/sealant to the sensor and inside the hole in the door post.
6. Press the sensor all the way into the 1/2" hole until it is fully seated.
7. Wipe off any excess adhesive/sealant.
Testing the Swing Door Sensor
1. Attach an ohmmeter to the sensor wires.
2. Close the door and check the ohmmeter for proper swing door sensor operation.
• When the door is closed, the ohmmeter should measure 0 ohms.
• When the door is open, the ohmmeter should measure an infinite resistance.
05AAA_22905AAA_229
Adhesive/Sealant
05AAA_207D
Sensor
Wires
Tail light
Assembly
DRAFT