User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 14-23
Performing System Verification Trailer Connection/Disconnection
If a trailer is not currently connected, the status is None Connected, as shown in the
following figure.
After the trailer is connected and the TrailerTRACS transmitter sends its ID to the
mobile communications terminal, the trailer ID is updated on the MVPc as shown in the
following screen.
Disconnection
1. Remove 7-way pigtail.
2. Leave ignition on.
3. Wait up to five minutes for disconnect message.
A disconnect message is sent when the tractor’s ignition is on and there has been no
signal from the tethered transmitter for a preset time period. This will usually occur
within five minutes.
DRAFT