User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 14-13
Performing System Verification 7-Way Tool Health Screen Information
7-Way Tool Health Screen Information
The 7-Way Tool Health screen lists the latest values detected from the terminal, including a
terminal’s registration status. If multiple terminals are detected, you can change the currently
viewed terminal by selecting a different terminal. To select a different terminal, tap the drop-
down arrow next to the terminal number (e.g., 120000001) near the upper-right corner of the
screen.
Note
If the 7-way diagnostic tool software cannot communicate with the terminal for approximately
two minutes, you are prompted with a message and the Connect screen redisplays. This
happens for any of the following reasons:
• The cable between the handheld device and the 7-way tool is disconnected.
• The 7-way tool battery is not charged or dead.
• Over-the-air (OTA) upgrade is being performed.
After resolving the issue, you can re-establish a connection to the terminal.
Diagnostic Values
The 7-way diagnostic tool software detects the current values of the following:
Terminal S/N
The TT210 system terminal serial number that the 7-way diagnostic tool software is
connected to. If the “No MCT” ( ) image appears, the terminal is configured so the mobile
communications terminal (MCT) will not recognize the data sent from this terminal.
Cargo Sensor Status
If installed, the cargo sensor status shows as: NOT INSTALLED, EMPTY/UNLOADING, or
LOADED/LOADING.
DRAFT