User's Manual Part 2

TT210 System Verification Procedure Performing System Verification
14-8
MAY CONTAIN U.S.AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
13. Does the Battery show a voltage rather than charging?
• If NO, cover the solar panel to turn off the charging circuit.
14. Is the Battery voltage 3.7 volts or higher?
NOTE: This verification must be done without external power applied to the TT210
system terminal. If external power is applied, the Battery voltage indicated on the
Configuration Tool software will be the charger voltage, not the actual TT210 system
terminal battery voltage.
Battery voltage below 3.7 volts indicates the battery needs to be charged.
• If YES, go to step 16.
• If NO, go to Chapter 23: TT210 System Diagnostics: Battery.
15. Uncover the solar panel if covered. Check that Sol voltage is greater than 6 volts in
direct sunlight.
• If NO, go to solar power chapter
.
16. If this installation does not include 7-way power, go to step 18.
17. If this installation includes 7-way power, apply external 7-way power to the TT210
system terminal.
7-way receptacle
04AAA_127E
Remove
external
power from
the 7-way
receptacle.
+
_
BATTERY
DRAFT