User's Manual Part 2

TT210 System Verification Procedure Performing System Verification
14-4
MAY CONTAIN U.S.AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
TT210 System Verification Procedure
1. Ensure that the following electrical connections are made:
External power should not be applied to the TT210 system terminal until except to start
Bluetooth.
• The blue (POWER) and white (GROUND) wires from the TT210 system power/
accessory cable are connected to the trailer’s 7-way.
• RF connections/antenna connections.
• Any installed optional sensor wires (cargo, door, and AUX) are properly connected.
Ensure that the following also apply:
• The TT210 system battery should be connected.
2. Be certain you have a functioning Bluetooth adapter on your PC.
3. To launch the TT210 Configuration tool software, Click the Connect Button on the
screen.
4. Activate the Bluetooth on the terminal via the 7-way power (for one trailer) or the key fob
(for a group of trailers).
NOTE: Bluetooth stays on for about 1 minute. If it turns off before you are ready,
activate again.
05AAA_217D
GRN
RED
YEL
BLK
BLU
BRN
White (GND)
Pin 1
Blue (PWR) Pin 7
3 amp Fuse
DRAFT