User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 14-3
Performing System Verification Diagnostic Flowchart—TT210 System Verification
Diagnostic Flowchart—TT210 System Verification
Step 2 Start the Cong Tool
software.
Click the Connect
button on your laptop.
Did it connect?
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Wake the unit either by
using the keyfob or applying
7-way power.
You have 1 minute to make
Bluetooth connection.
If Trailer ID has not been
entered (intial install), you
be prompted to do so.
Enter the Trailer ID.
Ensure all
electrical connections
are made.
Step 1
Ye s
Go to chapter 15;
Cong Tool
Will Not
Connect.
Ye s
No
No
No
Is the Trailer ID
displayed
correctly?
Go to chapter 16;
Changing the
Trailer ID.
No
If installed,
does the cargo sensor
toggle between Loading
and Unloading?
If installed,
does the door sensor
toggle between Open
and Closing?
Ye s
Ye s
Go to chapter 17;
Cargo Sensor.
Go to chapter 18;
Door Sensor.
If an AUX
sensor is installed,
does it toggle
between dierent
states?
Step 10
Ye s
In the GPS eld
does the tool
indicate 2D or
3D x?
No
Go to chapter 19;
AUX Sensor.
No
Go to chapter 20;
GPS No Fix.
No
Ye s
Go to chapter 23;
Battery.
Does
the battery
indicate 3.7 volts
or higher?
Step 11
Step 12
Step 13
Ye s Ye s
No
In reefer
type displayed?
Step 21
Ye s
No
Cover the solar
panel to turn o
the charging
circuit. Then
goto step 11.
Does
the battery
show a voltage
rather than
charging?
Ye s
No
Ye s
Go to chapter 25;
Solar Power.
Is the solar
voltage
greater than 6 volts
in direct
sunlight?
No
Ye s
Go to chapter 24;
External Power.
Is a valid
voltage for source
greater than
9 volts
showing?
No
Ye s
Go to step 21.
No
Go to chapter 29;
Reefer Diag.
Reefer voltage
section
Is this a
reefer
install?
With the
reefer running, is
reefer voltage approx
12 volts?
Disconnect 7-way and
reefer power if connected.
Step 14
Step 15
Step 16
Step 17
Step 18
Step 19
Step 20
Uncover the solar
panel if covered.
If using 7-way tool, the
Trailer ID should show
System Verication Complete
Apply 7-way power.
Go to chapter 29;
Reefer Diag.
Reefer data
section
No
Does
phone signal
strength show
two or more
bars?
Ye s
Go to chapter 26;
Phone Signal
Strength
Step 22
No
Does
registration
status show
Registered
Step 23
Ye s
Go to chapter 27;
System
Registration
DRAFT