User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 13-7
Installing the Auxiliary Sensor Parameter Defaults
Parameter Defaults
Settings displayed in the following table are specific to the tire pressure sensor application.
Other applications may require different initial and operational settings.
1. If the correct parameters have been set in TT210 Web or the AS400, release tire air
pressure by opening the valve on the tire pressure sensor switch box under the trailer.
This will cause the tire pressure warning light to illuminate.
2. With the Configuration tool is connected to the TT210 system, you will see AUX.
Sensor change from Closed to Opening then Open after validation on the
Configuration tool health screen, if the sensor has been properly wired to the TT210
system. It will take approximately 10 minutes to validate.
Modified Parameters Initial Settings Operational Settings
Parameter 1043
Sensor 4 Label:
Tire Pressure Alarm Label
Varies depending on
application
Parameter 1113
Sensor 4 Open Time:
5 Seconds 10 minutes
Varies depending on
application
Parameter 1114
Sensor 4 Close Time:
5 Seconds 10 minutes
Varies depending on
application
Parameter 1117
Send Sensor 4 Open:
Ignore Send Immediately
Varies depending on
application
Parameter 1118
Send Sensor 4 Close:
Ignore Ignore
Varies depending on
application
Parameter 1130
Sensor 4 Installed:
Uninstalled Installed
DRAFT