User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 11-3
Installing the Swing Door Sensor Swing Door Sensor Installation
Swing Door Sensor Installation
The recommended external installation procedure is to route the door sensor cable
underneath the trailer from the trailer nose where the TT210 system mount assembly is
located, to the rear where it will connect with the swing door sensor. The cable can route
along the left side, right side, or center underneath the trailer.
Note
The entire length of the 85-foot cable is covered with convoluted tubing. If there is any excess
cable, cut the excess cable and discard.
External Cable Installation Procedure
Note
The actual door sensor cable run location will vary between different trailer manufacturers.
1. Route the 85-foot door sensor cable assembly externally underneath the trailer from the
TT210 system mount assembly to the swing door sensor location along the same route
as the factory wiring and/or brake line. update figure
Orange
Orange
Yellow
Yellow
04AAA_211B
Inspection
holes
Magnet
Sensor
View rotated
to eye level
Cargo
Door
Door
Post
Wire enclosed in
convoluted tubing
TT210 System
Mount Assembly
To TT210
System
Mount
Assembly
Door Sensor Cable shown
routed underneath the trailer from
the TT210 System Mount Assembly to
the sensor at the rear of the trailer
either along the left side, right side,
or center of the trailer, as indicated.
DRAFT