User's Manual Part 2

Roll Door Sensor Installation Installing the Roll Door Sensor
12-6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
7. Drill a 1/2” hole at this point in the trailer floor.
8. Feed the sensor cable leads through the 1/2” hole and out the bottom of the trailer floor
into the area behind the taillight.
06AAA_217
5/8"
Drill a 1/2" hole, approximately 5/8" minimum
in from marked reference line and as close into the
corner as possible. Take care to drill straight down.
06AAA_21
0
Feed the armored cable
down into the 1/2" drilled hole.
DRAFT