User's Manual Part 2

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 12-5
Installing the Roll Door Sensor Roll Door Sensor Installation
4. Position the roll door sensor switch and mark the holes for the roll door sensor switch
using a 3/16" drill bit.
5. Remove the taillight assembly from the trailer’s passenger side. Most taillight
assemblies are held into place by a large rubber grommet.
6. Using a center punch, mark a spot on the trailer floor 5/8” minimum in from where the
vertical reference mark was made for the door sensor cable.
06AAA_211a
Taillight
Assembly
Rubber
Seal
Retainer
06AAA_221
DRAFT