User's Manual Part 1
Connect the TT210 Retrofitting for TT210
9-4
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
3. Replace the existing gasket with a new one.
Connect the TT210
1. Remove the battery cover from the TT210.
2. Feed the Hirose connector through the 7/8” hole and connect to the terminal.
3. Install the 7/8” split grommet around the cable in the plate.
4. Spool the remaining cable at the back of the plate and use zip ties to hold in place.
5. Install the TT210 retrofit plate over the existing studs in the trailer and attach the 24
nuts.
6. Install the TT210 battery.
7. Attach cover to the battery/cable compartment.
8. Perform system verification. See Chapter 14: Performing System Verification.
DRAFT