User's Manual Part 1

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 9-3
Retrofitting for TT210 Retrofit steps
Retrofit steps
Remove the TT200
1. Remove the 24 nuts holding the pan on the trailer. Save the nuts for installing the
TT210.
2. Pull the TT210 pan off leaving the terminal and battery attached to the pan.
3. Disconnect the cables from the TT200 unit. Cut the zip ties.
• Remove the 20-pin connector from the bottom of the TT200 unit.
• Remove both antenna connectors from the TT200 unit.
• Remove the TT200 battery connector.
Note
Save the hardware for possible reuse.
4. Remove the antenna assembly (if desired) and patch holes.
Prepping
1. Attach the retrofit cable to the exisiting TT200 20-pin connector.
2. Attach the TT210 to the retrofit plate using the supplied hardware.
Remove all 24 nuts
holding pan to trailer
Detach all cables
DRAFT