User's Manual Part 1

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 8-7
Installing the TT210 Terminal on Reefers Mount Overview
Mount Overview
The TT210 reefer mount attaches to the top rail of the trailer. The TT210 power/accessory
cable runs from the TT210 terminal to the 7-way receptacle.
Thoroughly evaluate the trailer area where the mount will be located to determine if the T2
system can be installed on the trailer. The trailer should be free of extensive damage in all
installation areas. For specific information on verifying a trailer’s condition, refer to Verify the
Trailer/Container Is in Good Condition on page 4-3. For specific tools required, refer to Tools
and Supplies Needed for Installation on page 4-6.
Before installing any T2 system component, refer to FCC Safety Information on page 4-2.
Mount Installation
Must install in xxxx spot depending on if Tk or Carrier due to airflow. If installed
incorrectly, it could restrict air flow from the Reefer unit and affect the Reefer’s
operation. See John Oeth or Kevin????
06AAA 136E
Reefer Unit
Reefer Mount
DRAFT