User's Manual Part 1

Installation Installing the TT210 Terminal on Containers
7-6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
NEED FIGURE> KEVIN TO GET JERRY DRAWING INFO...gromits etc.
7. Verify all mechanical and electrical components (cables, wires, optional sensors) are
properly connected.
8. Install the cargo sensor (follow directions in Chapter 10: Installing the Cargo Sensor)
9. Install the battery inside the terminal.
Place the battery into place, use provided zip ties, connect the connector, and install the
battery cover with provided screws. Only use hand tools when tightening the phillips
head screws on the battery cover.
10. Close the terminal and make sure it is sealed.
a. Ensure gasket is properly seated. (figure)
b. Attach the unit cover.
11. Configure or pair the terminal to the proper container ID.
a. Wake up the terminal with the key fob.
b. Using the configuration tool, go into the configure screen and enter the container
ID.
Connector
Battery Pack
B
attery Cover
10AAA_09B
DRAFT