User's Manual Part 1

Overview Installing the TT210 Terminal on Containers
7-2
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
Overview
The TT210 terminal installs outside the container on the container nose just below
(approximately 1/2") the top rail horizontal rivet line where the container skin attaches to the
top rail. Ensure the terminal clears the container’s top rail internally and externally, being
aware that the top rail may extend below the rivet line. The unit should be positioned as high
as possible on the driver’s side of center.
Thoroughly evaluate the container nose area (inside and outside) to determine if the TT210
system can be installed on the container. The container should be free of extensive damage
in all installation areas. For specific information on verifying a container’s condition, refer to
Verify the Trailer/Container Is in Good Condition on page 4-3. For specific tools required, refer
to Tools and Supplies Needed for Installation on page 4-6.
10AAA_01
This end up
Antenna
Battery Compartment
Solar Panel
Top View
10AAA_22
This end up
Bottom View
DRAFT