User's Manual Part 1

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 6-7
Installing the TT210 Terminal on Plate Nose Trailers Installation
b. Connect the white GROUND wire to pin 1 in the 7-way receptacle using a ring
terminal.
If the 7-way receptacle has circuit breakers, be sure to connect on the unprotected
(truck) side of the circuit breakers.
10. Connect the circular connector to the terminal. This connector is “keyed” and will only
go on in one position. Do not use excessive force.
11. Verify all mechanical and electrical components (cables, wires, optional sensors) are
properly connected.
12. Install the optional cargo sensor if used (follow directions in Chapter 10: Installing the
Cargo Sensor).
13. Install optional door or auxiliary sensors if used (Chapter 11: Installing the Swing Door
Sensor, Chapter 12: Installing the Roll Door Sensor, Chapter 13: Installing the Auxiliary
Sensor).
14. Install the battery inside the terminal.
Place the battery into place, use provided zip ties, attach the battery connector, iand
nstall the battery cover with provided screws. Only use hand tools when tightening the
phillips head screws on the battery cover.
05AAA_217E
GRN
RED
YEL
BLK
BLU
BRN
Blue (PWR) Pin 7
White (GND) Pin 1
3 amp Fuse
DRAFT