User's Manual Part 1

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 6-3
Installing the TT210 Terminal on Plate Nose Trailers Installation
unobstructed view of the inside of the trailer. Typically, it is mounted in the bay next to the
terminal. Determine which mount to use. Refer to Chapter 10: Installing the Cargo Sensor.
- If you have 3" from the inside skin to the outside liner, use a flat internal mount.
- If you have at least 2" but less than 3" from the skin to the outside liner, use a 1" pan.
- if container or plate nose use the 3" pan
• Door Sensor. The door sensor detects whether a trailer door is open or closed. Refer to
Chapter 11: Installing the Swing Door Sensor for product and installation instructions for
mounting the swing door sensor. Refer to Chapter 12: Installing the Roll Door Sensor for
product and installation instructions for mounting the roll door sensor.
• Auxiliary Sensor. The AUX wires on the TT210 system power/accessory cable offers the
option of using an auxiliary, customer-selected sensor with the TT210 system. Refer to
Chapter 13: Installing the Auxiliary Sensor for additional information regarding the
auxiliary sensor.
Read this chapter entirely before installing the terminal. The necessary tools, hardware, and
components can be positioned on a scaffold for easy access during the installation.
The power/accessory cable connects the TT210 system terminal to the trailer’s electrical
power source at the 7-way receptacle. It may be necessary to drill a hole through the 7-way
to provide a route from the electrical connections at the 7-way to the TT210 system terminal.
A 7.5 amp fuse is included for use on the TT210 system power/accessory cable blue
POWER wire.
Installation
1. On the outside of the trailer, locate the 7-way receptacle vertical bay where the TT210
terminal will be installed.
DRAFT