User's Manual Part 1

Installation Installing the TT210 Terminal on Dry Vans
5-8
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
b. Connect the white GROUND wire to pin 1 in the 7-way receptacle using a ring
terminal.
If the 7-way receptacle has circuit breakers, be sure to connect on the unprotected
(truck) side of the circuit breakers.
15. Mount the unit in the 7-way bay using the six rivets. These should be installed top, top,
middle, middle, bottom, bottom.
a. Remove battery/connector cover using a #1 Phillips screwdriver.
b. Put the round Hirose connector through the hole in the rear of the case and align
the hole with the grommet in the trailer skin.
c. Drill a 3/16" hole then attach the first rivet.
d. Level by measuring down from the top rail.
e. Drill another hole and attach the second rivet, then do the same for the rest of
rivets.
16. Connect the circular connector to the terminal. This connector is “keyed” and will only go
on in one position. Do not use excessive force.
17. Verify all mechanical and electrical components (cables, wires, optional sensors) are
properly connected.
18. Install the optional cargo sensor if used (follow directions in Chapter 10: Installing the
Cargo Sensor).
19. Install optional door or auxiliary sensors if used (Chapter 11: Installing the Swing Door
Sensor, Chapter 12: Installing the Roll Door Sensor, Chapter 13: Installing the Auxiliary
Sensor).
20. Install the battery inside the terminal.
05AAA_217E
GRN
RED
YEL
BLK
BLU
BRN
Blue (PWR) Pin 7
White (GND) Pin 1
3 amp Fuse
DRAFT