User's Manual Part 1

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 5-7
Installing the TT210 Terminal on Dry Vans Installation
c. Install the supplied split grommet on the cable going to the TT210 terminal where
the cable passes through the trailer skin.
Note
When installed on a plate nose trailer, the TT210 system power/accessory cable routes
externally down the outside nose of the trailer.
14. Make wire connections at the 7-way receptacle. Attach the fuse holder with 3 amp fuse
(provided) to the blue POWER wire on the TT210 system power/accessory cable using
a butt splice. (Fuse holder supplied in the power/accessory cable harness kit.)
a. Connect the blue POWER wire with the fuse holder to pin 7 in the 7-way
receptacle using a ring terminal.
10AAA_08
System Power/Accessory
Cable routed from the mount to
the 7-way connector
Dry Van
DRAFT