User's Manual Part 1

Tools and Supplies Needed for Installation TT210 Installation Planning
4-6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 80-J7615-1 Rev. A
Tools and Supplies Needed for Installation
The following tools and supplies are recommended for performing installations.
• Laptop with XP or higher for running the Configuration Tool software
• Pop-rivet gun (suitable for use with 1/4" rivets)
• Wire crimper/stripper/cutter
• Felt-tip pen (or grease pencil, or scratch awl)
• 7/16" deep socket and ratchet
• 1/2" deep socket and ratchet
• 3/8" nut driver or socket and ratchet
• Metal cutting shear
• Assorted 7-way receptacle tools
• 20-foot portable scaffold or 20-foot ladder
• Cable anchors/tie wraps
• Drill (battery only recommended)
• 3/8" drill bit
• 3/16" drill bit
• Assorted drill bits
Note
High-torque/low RPM drill motors should be used for all steel drilling.
• 7/8" hole saw
• Rubbing alcohol and a towel
• Fish tape for routing wires
• Assorted tools for removal of plywood (typically a 1/2" socket and ratchet, 3/8" nutdriver,
#2 Phillips screwdriver)
DRAFT