User's Manual Part 1

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 4-5
TT210 Installation Planning Typical TT210 Installation Sequence
Typical TT210 Installation Sequence
Trailers, containers, and flatbeds often differ from manufacturer to manufacturer. The TT210
system was designed to work with a variety of trailer/container types, however, every
installation is unique and should be thoroughly planned out before implementation.
1. Identify the installation location.
2. Mount the unit.
3. Route and connect cables and wires.
4. Identify which cargo sensor mount to use.
• If 3” from the skin to liner, use internal mount
• if > 3” from skin to liner, use 1” pan
• if container or plate note use the 3” pan
5. Install the optional cargo sensor and/or door sensor if desired.
6. Install battery into unit.
7. Close the unit.
8. Use the configuration tool software to configure the TT210 system and to verify the
system is working properly. The software is also used to diagnose any problems with
the system.
9. Perform system verification.
DRAFT