User's Manual

TT210 System Cargo Sensor Validation Installing the Cargo Sensor
11-12
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
TT210 System Cargo Sensor Validation
The TT210 system terminal’s cargo sensor default setting will “wake up” the cargo sensor
every 30 minutes and check for a cargo load.
This is customer configurable. The terminal can be customer configured to:
• Message immediately
• Send on next report
• Respond to a ping
• Ignore
An ultrasonic sensor detects objects approximately 20 feet back from the nose of the trailer.
The interval is set up per the customer’s request and state change reports are sent to the
customer, as shown in the following illustration.
Not Installed
Loading Loaded
Loaded
Time Zero
Validation Time
Validated
Set at NMC/Host
Default: 3 attempts
10 minutes apart
before a load is
confirmed. Both
parameters are
configurable.
Unloading
T2 System Cargo Sensor Validation
05AAA_026
Empty
Note:
FST s/w forces
5-second check
interval. Door and
connect events
also force readings.
Time Zero
Validated
Validation Time
DRAFT