User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 15-31
Performing System Verification Maintaining the Tethered System on Tractors
Maintaining the Tethered System on Tractors
Do the following to ensure optimum system performance on the tractor:
• Secure cables from movement.
• Cover any exposed cables with convoluted tubing.
• Inspect, clean, and apply dielectric grease to all 7-way connection points.
• Verify that the 7-way cord is free from cuts and abrasions.
• Verify that voltage (12–24 V) on pin 7 at all 7-way connection points.
Maintaining the Tethered System on Trailers
Do the following to ensure optimum system performance on the trailer:
• Secure and cover any exposed cabling with convoluted tubing.
• Inspect, clean, and apply dielectric grease to all 7-way connection points.
• If necessary, open the face plate and clean the inside of the receptacle.
Troubleshooting
System Verification Form
On the following page is the TT210 System Verification Form. You can make copies of this
form and record important information concerning the trailer and the TT210 system.
Note
To access the information for the TT210 System Verification Form, you must use the TT210
Config Tool software.
Problem Solution
Connection:
Will not connect to tractor. 1. Is Auto Connect enabled?
2. Check 5-amp fuse on the mobile communications
terminal TTRACS wire.
Disconnection:
Will not disconnect. 1. Disconnect tractor 7-way pigtail.
2. Turn key to the ON position (could take up to five
minutes for the disconnect to occur).
DRAFT