User's Manual

Trailer Connection/Disconnection Performing System Verification
15-22
MAY CONTAIN U.S.AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
4. Press  until the TrailerTRACS ID screen is displayed.
If “Hit C to Connect” (see illustration below) is displayed on the screen, Auto Connect is
not enabled. Call the QES Customer Support to enable Auto Connect. In the United
States, call 800-541-7490; in Canada, call 800-863-9191. Have the mobile
communications terminal serial number (unit address) available when you call.
If a trailer is not currently connected, the status is None Connected, as shown in the
following screen.
After the trailer is connected and the TrailerTRACS system transmitter sends its ID to
the mobile communications terminal, the trailer ID is updated on the display unit as
shown in the following screen.
Disconnection
1. Remove 7-way pigtail.
2. Leave ignition on.
USE ↑ (↓) TO MOVE TO PREV (NEXT) SCREEN
TRAILERTRACS ID#'s (HIT "C" TO CONNECT)
CONNECTED: NONE CONNECTED
USE ↑ (↓) TO MOVE TO PREV (NEXT) SCREEN
TRAILERTRACS ID#'s
CONNECTED: NONE CONNECTED
USE ↑ (↓) TO MOVE TO PREV (NEXT) SCREEN
TRAILERTRACS ID#'s
CONNECTED: 1234
DRAFT