User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 15-21
Performing System Verification Tethered Asset Management Service Overview
Tethered Asset Management Service Overview
The tethered asset management service is an option that allows dispatch to monitor trailer
connections and disconnections. Connects and disconnects are detected by the mobile
communications terminal and passed on to dispatch via the satellite link with the date, time,
and location.
Firmware Requirements
The mobile communications terminal firmware version must be 15.50 or above for the
tethered asset management service option. If the mobile communications terminal firmware
version is below 15.50, contact your Regional Qualcomm Customer Support Specialist.
Getting the TT210 System Terminal ID (DU)
The screens you view when verifying trailer connections and disconnections are different
depending on the type of display unit being used. This first section describes the method
used with a display unit (DU). The following sections describe the method used with the
enhanced display unit (EDU) and the MVPc in-vehicle computer.
If you are using an EDU, go directly to page 15-24 for proper instructions. If you are using an
MVPc in-vehicle computer, go directly to page 15-28 for proper instructions.
This section provides information on system verification for single trailer connections and
disconnections.
Enable Tethered Asset Management Service and Auto Connect
Note
If tethered asset management service screens are not available, then the tethered asset
management service option is not enabled.
To activate the mobile communications terminal for the tethered asset management service
option and to enable Auto Connect, call the QES Customer Support. In the United States, call
800-541-7490; in Canada, call 800-863-9191.
Trailer Connection/Disconnection
This section provides system verification information on trailer connections/disconnections.
Connection
1. Turn on the ignition.
2. Hook up the tractor to the trailer, connect the tractor’s 7-way pigtail.
3. Press the OPTION key from the View Status screen.
DRAFT