User's Manual

Installing the Cargo Sensor Using a Flat Internal Mount Installing the Cargo Sensor
11-10
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
3. Center the cargo sensor side to side in the hole. The bottom edge of the plywood hole
should be a minimum of 6” below the lower lip of the cargo sensor cone.
4. From the inside of the trailer, while holding the mount in place, drill four 3/16” rivet holes.
It may be possible to tape the mount temporarily to hold it in place for drilling and
riveting.
5. This step will require two people to perform. While holding the mount in place, install
the provided rivets from the outside of the trailer and rivet mount to the trailer skin.
Trailer Exterior
Cargo Sensor Mount
Riveted to Trailer skin
10AAA_48
Trailer Skin
Cut Interior
Plywood for
Cargo sensor
Rivet
4 Places
10AAA_21A2
Trailer Exterior
Mounting plate
Riveted to Trailer skin
DRAFT