User's Manual

TT210 System Verification Procedure Performing System Verification
15-16
MAY CONTAIN U.S.AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
20. If using the 7-way tool, verify the TT210
system terminal’s serial number (S/N; top
right-hand area of the Configuration tool
software Health screen) has transmitted via
the 7-way on the trailer. This can also be
verified in any of the following ways
depending on what hardware is available:
To verify the trailer ID using the 7-way
diagnostic tool go to Getting the TT210
System Terminal ID Using the 7-way
Diagnostic Tool on page 15-17.
To verify the trailer ID for an OmniTRACS unit
using a display unit (DU) go to Getting the
TT210 System Terminal ID (DU) on
page 15-21.
To verify the trailer ID for an OmniTRACS unit
using an enhanced display unit (EDU) go to
Getting the TT210 System Terminal ID (EDU)
on page 15-24.
To verify the trailer ID for an OmniTRACS unit
using an MVPc
®
in-vehicle computer go to
Getting the TT210 System Terminal ID
(MVPc) on page 15-28.
•If YES, system verification is complete.
•If NO and you are using the 7-way
diagnostic tool, go to Chapter 29: TT210
System Diagnostics: Power Bus Modem.
DRAFT