User's Manual

TT210 System Verification Procedure Performing System Verification
15-12
MAY CONTAIN U.S.AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
10. Make sure no external power (i.e., reefer, 7-
way) is applied. Go to step 11.
11. Is the Battery voltage 3.7 volts or higher?
NOTE: This verification must be done without
external power applied to the TT210 system
terminal. If external power is applied, the
Battery voltage indicated on the Configuration
Tool software will be the charger voltage, not
the actual TT210 system terminal battery
voltage.
Battery voltage below 4.0 volts indicates
the battery needs to be charged.
•If YES, go to step 12.
•If NO, go to Chapter 24: TT210 System
Diagnostics: Battery.
7-way receptacle
04AAA_127E
Remove
external
power from
the 7-way
receptacle.
+
_
BATTERY
DRAFT