User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 11-9
Installing the Cargo Sensor Installing the Cargo Sensor Using a Flat Internal Mount
Installing the Cargo Sensor Using a Flat Internal Mount
Note
Mount on the bay next to the TT210 terminal which will be on the driver’s side (left of
center) no closer than 18" to the trailer sidewall.
1. Locate the mounting position of the cargo sensor. It should be centered in the bay next
to the TT210 terminal which will be on the driver’s side (left of center).
2. Measure and cut a hole approximately 9 1/2” x 12 “ in the liner that allows the cargo
sensor an unobstructed view of the inside of the trailer.
Container
Plate Nose
Plate Nose and Containers
Use 3" Pan
External Wiring
Dry Van
Use 3" or 1" Pan
Internal Wiring
DRAFT