User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 15-7
Performing System Verification TT210 System Verification Procedure
3. Tap . Please allow up to two minutes
for the Configuration tool software to connect.
Did the Configuration tool software connect to
the TT210 system terminal?
• If YES, go to step 4.
• If NO, the failure to connect Alert screen
will appear. Tap OK to clear the Alert
screen. Check cable connections and tap
again. Does the Configuration tool
software connect now?
- If YES, go to step 4.
- If NO, go to Chapter 16: TT210 System
Diagnostics: Configuration Tool Will Not
Connect.
NOTE: The following pop-up screen
appears each time the unit goes into a call.
DRAFT