User's Manual

Installing the Cargo Sensor Using 3" or 1" Pan Mount Installing the Cargo Sensor
11-8
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
17. Mount the cargo sensor to the 3" or 1"cargo sensor pan mount using four lock nuts and
four flat washers. Tighten just until snug and torque to 20 inch-pounds +/- 5 inch-
pounds.
18. For a container or plate nose:
a. Place the grommet around the cargo sensor connector and down the cable about
9".
b. Route the cable through the 7/8" hole in the bottom of the 3" pan and connect to
the sensor.
c. Fit the grommet securely into the 7/8" hole and adjust the cable length so it does
not protrude into the area in front of the cargo sensor.
19. For a dry van:
a. Reach into the hole and grab the cargo sensor cable.
b. Connect the cable to the cargo sensor.
c. Secure the cargo sensor cable so that it does not fall into the area in front of the
cargo sensor.
20. Position the mount into place, lining it up with the studs. Press firmly to secure over the
gasket.
21. Fasten supplied nuts over each stud and tighten to spec 80 inch-pounds +/- 9 inch-
pounds.
10AAA_010A
DRAFT