User's Manual

Tire Pressure Sensor Kit Validation Installing the Auxiliary Sensor
14-6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
Tire Pressure Sensor Kit Validation
A simple opened/closed switch detects tire pressure. The validation time is set up per the
customer’s request and state change reports are sent to the customer, as shown in the
following illustration.
1. In order to validate default settings and verify if the tire pressure sensor is working
correctly with the TT210 system, certain TT210 system parameters must be set at the
customer site using the TT210 Web application or the AS400 system. To find out if the
parameters have been set, contact QES Customer Support.
United States: 800-541-7490
Canada: 800-863-9191
Default parameters may vary by customers.
TT210 System AUX Sensor Validation
05AAA_026a
Closing Closed
Time Zero
Validation Time Validated Event
Set at NMC or Host
Default 10 minutes
Open
Closed
Opening
Simple open and closed switch that detects a changed state immediately
and reports as configured by the customer.
Time Zero
Validated Event
Validation Time
Note:
FST s/w forces
5-second check
interval.
Open
DRAFT