User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 11-7

Installing the Cargo Sensor Installing the Cargo Sensor Using 3" or 1" Pan Mount

14. Remove the protective plastic cover from the double-sided adhesive tape on each of

the four prefabricated stud plates.

15. Each of the four stud plates are installed on the inside of the trailer skin. Position each

to line up with the stud holes that were just drilled. Push the studs through the holes and

press firmly to adhere the stud plate to the inside of the trailer skin.

16. There is a gasket supplied with the mount. With the studs now protruding through the

outside of the trailer skin, place the gasket over the studs and against the trailer skin.

Gasket is one time use only. Replace the gasket each time the pan is removed and

reinstalled

04AAA _135A

Stud Plate

Double-sided Tape

04AAA_137C

DRAFT