User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 13-13
Installing the Roll Door Sensor Roll Door Sensor Installation Verification
Roll Door Sensor Installation Verification
1. At the back of the trailer, butt splice the white sensor wires to the orange and yellow
cable wires. Add additional strain relief by following the procedure on page 3-7.
Note
The sensor is a simple switch device; polarity does not matter.
2. Cover butt splices with convoluted and store excess wire behind the taillight assembly.
3. Replace the taillight assembly.
05AAA_246A
When the test is completed
and the circuit tests O.K. , splice
the sensor wires to the terminal wires.
Yellow
Orange
Taillight
Rubber
Seal
Retainer
06AAA_219
DRAFT