User's Manual

Roll Door Magnet Installation Installing the Roll Door Sensor
13-8
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
Roll Door Magnet Installation
Note
The bottom of the trailer door may have a metal strip. Placement of the magnet may pitch the
angle of the magnet forward over the roll door sensor switch. As long as the magnet is
positioned within one inch of the top of the roll door sensor switch, the roll door sensor will
operate properly.
1. Inside the trailer with the trailer door rolled down, mark the vertical and horizontal
reference lines on the bottom of the roll door so the roll door sensor switch and magnet
can be easily aligned. Refer to the following two illustrations.
Mark the vertical location for
mounting the magnet.
06AAA_214
DRAFT