User's Manual

Installing the Cargo Sensor Using 3" or 1" Pan Mount Installing the Cargo Sensor
11-6
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
9. Remove the self-drilling screws and the template.
10. Drill a 7/8" hole on each of the four corners of the template using the pilot holes as a
guide.
11. Completely cut out the marked area for the cargo sensor with a cutting tool, being
careful not to drop the newly cut panel inside or outside of the trailer. Avoid sharp edges
and debur if necessary.
12. Verify the trailer skin around the cutout area (inside and outside the trailer) is free of dirt
and grime. If not, clean the surface with alcohol.
13. Drill four holes in the plywood liner that are lined up with the four 7/8" holes in the trailer
skin. Mark and cut out the plywood in the area inside the four holes. The plywood cutout
must extend a minimum of 6" below the lower edge of the cargo sensor cones at the
bottom.
Note
If the 3" pan is used with a trailer having a greater than 2” spacing, increase plywood
cutout 3" lower (9" below cargo sensor).
Scribed
Line
Drill four 7/8" corner holes
DRAFT